Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 784)

728 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
34
Trunk Configuration
FIGURE 58 Configuring Connection Parameters for a Static Trunk
To display trunk connection parameters:
1. Click Interface, Trunk, Static.
2. Select Configure General from the Step list.
3. Select Show Information from the Action list.
FIGURE 59 Showing Information for Static Trunks
Configuring a Dynamic Trunk
Use the Interface > Trunk > Dynamic pages to set the administrative key for an aggregation group,
enable LACP on a port, configure protocol parameters for local and partner ports, or to set Ethernet
connection parameters.
FIGURE 60 Configuring Dynamic Trunks
CLI References
• “Link Aggregation Commands” on page 285
Command Usage
• To avoid creating a loop in the network, be sure you enable LACP before connecting the ports,
and also disconnect the ports before disabling LACP.
• If the target switch has also enabled LACP on the connected ports, the trunk will be activated
automatically.
active
links
}
}
dynamically
enabled
configured
members
backup
link