Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 334)

278 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
12
Interface Commands
Vendor OUI : 00-05-1E
Vendor Name : BROCADE
Vendor PN : 33210-100
Vendor Rev : A
Vendor SN : TAF11119000075U
Date Code : 11-05-06
DDM Info
Temperature : 31.62 degree C
Vcc : 3.27 V
Bias Current : 5.48 mA
TX Power : -5.45 dBm
RX Power : -33.01 dBm
DDM Thresholds
Low Alarm Low Warning High Warning High Alarm
----------- ------------ ------------ ------------ ------------
Temperature(Celsius) -123.00 0.00 70.00 75.00
Voltage(Volts) 3.10 3.15 3.45 3.50
Current(mA) 6.00 7.00 90.00 100.00
TxPower(dBm) -12.00 -11.50 -9.50 -9.00
RxPower(dBm) -21.50 -21.00 -3.50 -3.00
Console#
Cable Diagnostics
test cable-diagnostics
This command performs cable diagnostics on the specified port to diagnose any cable faults
(short, open, etc.) and report the cable length.
Syntax
test cable-diagnostics interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
Command Mode
Privileged Exec
Command Usage
• Cable diagnostics are performed using Digital Signal Processing (DSP) test methods. DSP
analyses the cable by sending a pulsed signal into the cable, and then examining the reflection
of that pulse.
• This cable test is only accurate for cables 7 - 140 meters long.
• The test takes approximately 5 seconds. The switch displays the results of the test immediately
upon completion, including common cable failures, as well as the status and approximate
length of each cable pair.
• Potential conditions which may be listed by the diagnostics include:
• OK: Correctly terminated pair
• Open: Open pair, no link partner