Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 404)

348 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
18
Spanning Tree Commands
Related Commands
“spanning-tree mst cost” on page 346
spanning-tree port-bpdu-flooding
This command floods BPDUs to other ports when spanning tree is disabled globally or disabled on
a specific port. Use the no form to restore the default setting.
Syntax
[no] spanning-tree port-bpdu-flooding
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• When enabled, BPDUs are flooded to all other ports on the switch or to all other ports within
the receiving port’s native VLAN as specified by the
spanning-tree system-bpdu-flooding
command.
• The spanning-tree system-bpdu-flooding command has no effect if BPDU flooding is disabled
on a port by the spanning-tree port-bpdu-flooding command.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-bpdu-flooding
Console(config-if)#
spanning-tree port-priority
This command configures the priority for the specified interface. Use the no form to restore the
default.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
priority - The priority for a port. (Range: 0-240, in steps of 16)
Default Setting
128
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command defines the priority for the use of a port in the Spanning Tree Algorithm. If the
path cost for all ports on a switch are the same, the port with the highest priority (that is,
lowest value) will be configured as an active link in the spanning tree.