Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 812)

756 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
35
IEEE 802.1Q VLANs
Edit Member by Interface
All parameters are the same as those described under the preceding section for Edit Member by
VLAN.
Edit Member by Interface Range
All parameters are the same as those described under the earlier section for Edit Member by VLAN,
except for the items shown below.
• Port Range – Displays a list of ports. (Range: 1-12)
• Trunk Range – Displays a list of ports. (Range: 1-12)
NOTE
The PVID, acceptable frame type, and ingress filtering parameters for each interface within the
specified range must be configured on either the Edit Member by VLAN or Edit Member by Interface
page.
Interface
To configure static members by the VLAN index:
1. Click VLAN, Static.
2. Select Edit Member by VLAN from the Action list.
3. Set the Interface type to display as Port or Trunk.
4. Modify the settings for any interface as required.
5. Click Apply.
FIGURE 84 Configuring Static Members by VLAN Index
To configure static members by interface:
1. Click VLAN, Static.
2. Select Edit Member by Interface from the Action list.
3. Select a port or trunk configure.
4. Modify the settings for any interface as required.
5. Click Apply.