Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 417)

Brocade 6910 Ethernet Access Switch Configuration Guide 361
53-1002651-02
19
ERPS Commands
Default Setting
0
Command Mode
ERPS Configuration
Command Usage
• This parameter is used to ensure that received R-APS PDUs are directed for this ring. A unique
level should be configured for each local ring if there are many R-APS PDUs passing through
this switch.
• If CFM continuity check messages are used to monitor the link status of an ERPS ring node as
specified by the
mep-monitor command, then the MEG level set by the meg-level command
must match the authorized maintenance level of the CFM domain to which the specified MEP
belongs.
Example
Console(config-erps)#meg-level 0
Console(config-erps)#
Related Commands
“ethernet cfm domain” on page 524
“ethernet cfm mep” on page 528
mep-monitor
This command specifies the CFM MEPs used to monitor the link on a ring node. Use the no form to
restore the default setting.
Syntax
mep-monitor {east | west} mep mpid
east - Connects to next ring node to the east.
west - Connects to next ring node to the west.
mpid – Maintenance end point identifier. (Range: 1-8191)
Default Setting
None
Command Mode
ERPS Configuration
Command Usage
• If this command is used to monitor the link status of an ERPS node with CFM continuity check
messages, then the MEG level set by the
meg-level command must match the authorized
maintenance level of the CFM domain to which the specified MEP belongs.
• To ensure complete monitoring of a ring node, use the mep-monitor command to specify the
CFM MEPs used to monitor both the east and west ports of the ring node.