Configuring rmon statistical samples, Figure 281 s – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 1036
980
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
43
Remote Monitoring
FIGURE 281
Showing Collected RMON History Samples
Configuring RMON Statistical Samples
Use the Administration > RMON (Configure Interface - Add - Statistics) page to collect statistics on a
port, which can subsequently be used to monitor the network for common errors and overall traffic
rates.
CLI References
•
Command Usage
•
If statistics collection is already enabled on an interface, the entry must be deleted before any
changes can be made.
•
The information collected for each entry includes:
input octets, packets, broadcast packets, multicast packets, undersize packets, oversize
packets, CRC alignment errors, jabbers, fragments, collisions, drop events, and frames of
various sizes.
Parameters
These parameters are displayed:
•
Port – The port number on the switch.
•
Index - Index to this entry. (Range: 1-65535)
•
Owner - Name of the person who created this entry. (Range: 1-127 characters)
Interface
To enable regular sampling of statistics on a port:
1. Click Administration, RMON.
2. Select Configure Interface from the Step list.
3. Select Add from the Action list.
4. Click Statistics.
5. Select a port from the list as the data source.
6. Enter an index number, and the name of the owner for this entry