Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 752)

696 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
33
Displaying CPU Utilization
Displaying CPU Utilization
Use the System > CPU Utilization page to display information on CPU utilization.
CLI References
• “show process cpu” on page 59
Parameters
The following parameters are displayed:
• Time Interval – The interval at which to update the displayed utilization rate. (Options: 1, 5, 10,
30, 60 seconds; Default: 1 second)
• CPU Utilization – CPU utilization over specified interval.
Interface
To display CPU utilization:
1. Click System, then CPU Utilization.
2. Change the update interval if required. Note that the interval is changed as soon as a new
setting is selected.
FIGURE 26 Displaying CPU Utilization
Displaying Memory Utilization
Use the System > Memory Status page to display memory utilization parameters.
CLI References
• “show memory” on page 58