Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 563)

Brocade 6910 Ethernet Access Switch Configuration Guide 507
53-1002651-02
24
LLDP Commands
lldp dot1-tlv proto-vid
This command configures an LLDP-enabled port to advertise port-based protocol VLAN
information. Use the no form to disable this feature.
Syntax
[no] lldp dot1-tlv proto-vid
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the port-based protocol VLANs configured on this interface (see
“Configuring
Protocol-based VLANs” on page 400).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv proto-vid
Console(config-if)#
lldp dot1-tlv pvid
This command configures an LLDP-enabled port to advertise its default VLAN ID. Use the no form
to disable this feature.
Syntax
[no] lldp dot1-tlv pvid
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The port’s default VLAN identifier (PVID) indicates the VLAN with which untagged or priority-tagged
frames are associated (see the
switchport native vlan command).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv pvid
Console(config-if)#