Required connections – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 68
12
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
2
Connecting to the Switch
•
Configure the bandwidth of any port by limiting input or output rates
•
Control port access through IEEE 802.1X security or static address filtering
•
Filter packets using Access Control Lists (ACLs)
•
Configure up to 4093 IEEE 802.1Q VLANs
•
Enable GVRP automatic VLAN registration
•
Configure IGMP multicast filtering
•
Upload and download system firmware or configuration files via HTTP (using the web interface)
or FTP/TFTP (using the command line or web interface)
•
Configure Spanning Tree parameters
•
Configure Class of Service (CoS) priority queuing
•
Configure static or LACP trunks (up to 6)
•
Enable port mirroring
•
Set storm control on any port for excessive broadcast, multicast, or unknown unicast traffic
•
Display system information and statistics
Required Connections
The switch provides an RS-232 serial port that enables a connection to a PC or terminal for
monitoring and configuring the switch. A null-modem console cable is provided with the switch.
Attach a VT100-compatible terminal, or a PC running a terminal emulation program to the switch.
You can use the console cable provided with this package, or use a null-modem cable that
complies with the wiring assignments shown in the Installation Guide.
To connect a terminal to the console port, complete the following steps:
1. Connect the console cable to the serial port on a terminal, or a PC running terminal emulation
software, and tighten the captive retaining screws on the DB-9 connector.
2. Connect the other end of the cable to the RS-232 serial port on the switch.
3. Make sure the terminal emulation software is set as follows:
•
Select the appropriate serial port (COM port 1 or COM port 2).
•
Set the baud rate to 9600 bps.
•
Set the data format to 8 data bits, 1 stop bit, and no parity.
•
Set flow control to none.
•
Set the emulation mode to VT100.
•
When using HyperTerminal, select Terminal keys, not Windows keys.
NOTE
Once you have set up the terminal correctly, the console login screen will be displayed.
For a description of how to use the CLI, see
“Using the Command Line Interface”
on page 27. For a
list of all the CLI commands and detailed information on using the CLI, refer to