Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 381)

Brocade 6910 Ethernet Access Switch Configuration Guide 325
53-1002651-02
17
Address Table Commands
clear mac-address-table dynamic
This command removes any learned entries from the forwarding database.
Default Setting
None
Command Mode
Privileged Exec
Example
Console#clear mac-address-table dynamic
Console#
show mac-address-table
This command shows classes of entries in the bridge-forwarding database.
Syntax
show mac-address-table [address mac-address [mask]] [interface interface] [vlan vlan-id]
[sort {address | vlan | interface}]
mac-address - MAC address.
mask - Bits to match in the address.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
vlan-id - VLAN ID (Range: 1-4093)
sort - Sort by address, vlan or interface.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The MAC Address Table contains the MAC addresses associated with each interface. Note that
the Type field may include the following types:
• Learn - Dynamic address entries
• Config - Static entry