Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 254)

198 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
10
Network Access (MAC Address Authentication)
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
• The VLAN to be used as the guest VLAN must be defined and set as active (See the vlan
database command).
• When used with 802.1X authentication, the intrusion-action must be set for “guest-vlan” to be
effective (see the
dot1x intrusion-action command).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access guest-vlan 25
Console(config-if)#
network-access link-detection
Use this command to enable link detection for the selected port. Use the no form of this command
to restore the default.
Syntax
[no] network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection
Console(config-if)#
network-access link-detection link-down
Use this command to detect link-down events. When detected, the switch can shut down the port,
send an SNMP trap, or both. Use the no form of this command to disable this feature.
Syntax
network-access link-detection link-down action [shutdown | trap | trap-and-shutdown]
no network-access link-detection
action - Response to take when port security is violated.
shutdown - Disable port only.
trap - Issue SNMP trap message only.
trap-and-shutdown - Issue SNMP trap message and disable the port.