Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1129)

Brocade 6910 Ethernet Access Switch Configuration Guide 1073
53-1002651-02
44
Address Resolution Protocol
FIGURE 350 Displaying Static ARP Entries
Displaying ARP Entries
Use the IP > ARP (Show Information) page to display dynamic entries in the ARP cache. The ARP
cache contains entries for local interfaces, including subnet, host, and broadcast addresses. These
entries are dynamically learned through replies to broadcast messages.
CLI References
• “show arp” on page 604
• “clear arp-cache” on page 604
Command Usage
Static entries are only displayed for VLANs that are up. In other words, static entries are only
displayed when configured for the IP subnet of a existing VLAN, and that VLAN is linked up.
Interface
To display all dynamic entries in the ARP cache:
1. Click IP, ARP.
2. Select Show Information from the Step List.
3. Click Dynamic Address.
FIGURE 351 Displaying ARP Entries
To display all local entries in the ARP cache:
1. Click IP, ARP.
2. Select Show Information from the Step List.
3. Click Other Address.