Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 953)

Brocade 6910 Ethernet Access Switch Configuration Guide 897
53-1002651-02
42
Access Control Lists
9. If you select “Host,” enter a specific address (e.g., 11-22-33-44-55-66). If you select “IP,” enter
a base address and a hexadecimal bit mask for an address range.
10. Enable logging if required.
11. Click Apply.
FIGURE 213 Configuring a ARP ACL
Binding a Port to an Access Control List
After configuring ACLs, use the Security > ACL > Configure Interface (Configure) page to bind the
ports that need to filter traffic to the appropriate ACLs. You can assign one IP access list and one
MAC access list to any port.
CLI References
• “ip access-group” on page 238
• “show ip access-group” on page 239
• “mac access-group” on page 248
• “show mac access-group” on page 248
• “Time Range” on page 101
Parameters
These parameters are displayed:
• Type – Selects the type of ACLs to bind to a port.
• Port – Port identifier.
• ACL – ACL used for ingress or egress packets.
• Time Range – Name of a time range.
• Counter – Enables counter for ACL statistics.