Canon imageCLASS MF7470 - Manual (Page 103)

1
2
3
4
5
6
7
8
9
10
11
3-32
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
7. Enter a name, then press [OK].
The maximum number of characters that you can enter for a key
name is 10.
The assigned name appears on the key.
If you press [OK] without entering any characters, the key name
reverts to its current name (M1 to M4).
8. Press [Cancel].
9. Press [Done].
Pressing [Cancel] → [Done] only names the selected key ([M1] to
[M4]), but does not recall the stored settings. If you press [OK] →
[Done], the name is stored in the selected key ([M1] to [M4]), and the
settings are recalled at the same time.
Recalling Copy Settings
1. Press (COPY).
2.
Press [Special Features].
3. Press [Mode Memory].
4. Select the key containing the copy settings that
you want to recall.
5. Verify the settings, then press [OK].
6. Press [Done].
If you select a key that does not have copy settings stored in it, [OK]
is grayed out and cannot be pressed. Select another key that has
copy settings stored in it, or press [Cancel].
Recalling copy settings from memory cancels the current copy
settings.
You can make changes to the recalled copy settings.
If you press another key, the copy settings stored in that key are
recalled.
Erasing Copy Settings
1. Press (COPY).
2.
Press [Special Features].
3. Press [Mode Memory].
4. Press [Store/Erase].
5.
Press [Erase].
–
–
–