Canon imageCLASS MF7470 - Manual (Page 54)

1
2
3
4
5
6
7
8
9
10
11
2-6
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
If the top edge of the original is not aligned with the back edge of the
platen glass (by the arrow in the top left corner), your original may not be
scanned correctly, depending on the scan mode that you have set.
Originals of the following sizes can be placed either vertically or
horizontally. However, the scanning speed for horizontally placed
originals is somewhat slower than vertically placed ones. Place originals
horizontally when scanning with a Preset Zoom, such as when enlarging
an LTR original onto 11" x 17" paper.
Platen glass: LTR, STMT
Feeder: LTR
Horizontally placed LTR and STMT originals are referred to as LTRR and
STMTR.
11" x 17" and LGL originals must be placed horizontally on the feeder.
–
–
–
–
–
–
On the Platen Glass
The machine automatically detects the size of the following originals: 11" x
17", LGL, LTR, and LTRR.
1. Lift the feeder.
This machine is equipped with an open/close sensor (A) on the
feeder (see circled area in the above illustration). When placing
originals on the platen glass, lift the feeder high enough so that the
sensor does not touch the feeder. If the sensor continues to touch
the feeder, the size of the originals may not be detected correctly.
■