Canon imageCLASS MF7470 - Manual (Page 141)

1
2
3
4
5
6
7
8
9
10
11
4-30
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
2. Check or change the destination’s information.
If the destination has been specified using any method
other than New Address tab:
Check the destination’s information, then press [Done].
If the destination has been specified using one of the
sending methods in the New Address tab:
Check or change the destination’s information, then press [OK].
Change the destination’s information in the same way that you
specified it. (See “Using the New Address Tab,” on p. 4-21.)
●
–
●
–
If the destination is a group address:
To check the information of registered destinations in a group
address, select one destination at a time, then press [Details].
Check the destination’s information, then press [Done], then
[Done].
Erasing a Destination
You can erase a specified destination from the destination list
before you scan your documents.
1. Select the destination to be erased.
If only one destination is specified, skip this step.
If the destination that you want to check or change is not displayed,
press [
▼] or [▲] to scroll to the desired destination.
2. Press [Erase].
●
–
–
■