Canon imageCLASS MF7470 - Manual (Page 403)

1
2
3
4
5
6
7
8
9
10
11
11-20
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Table of Contents
Index
Printer Settings
1. IMAGE REFINEMENT Sets whether to print smoothly the jagged outlines of characters and graphics.
ON
OFF
The results of image refinement may be different depending on the types of characters and graphics you
want to print.
–
–
2. DENSITY Adjusts the print density. (1-9)
3. TONER SAVER Sets whether the toner saving mode is enabled.
OFF
ON
If [ON] is selected for Toner Saver, very light or finely detailed images may not be printed clearly.
–
–
6. PAGE LAYOUT Sets the printing layout.
1. BINDING Sets the binding position for two-sided printing.
LONG EDGE
SHORT EDGE
You cannot create a binding margin with this setting alone. Use this setting in combination with the
Margin setting to create a binding margin.
For two-sided printing, the orientation of the image on the back side of the page may be changed by
this setting.
–
–
–
–
2. MARGIN Sets the page margin in inches or millimeters.
INCHES (-01.90INCHES–01.90INCHES)
mm (-50.0 mm–50.0 mm)
If this setting moves the image outside the printable area, part of the image may be cut off.
Pressing [
▶] increases the setting value by 0.01" (0.5 mm) each time the key is pressed. Pressing [◀]
decreases the value by 0.01" (0.5 mm) each time. Holding down either [ ◀] or [▶] continuously speeds
up the value alteration.
–
–
–
–