Canon imageCLASS MF7470 - Manual (Page 97)

1
2
3
4
5
6
7
8
9
10
11
3-26
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
3. Press [Special Features].
4.
Press [Frame Erase].
5. Press [Original Frame Erase], then [Next].
6. Select the original size , then press [Next].
You can set the Original Frame Erase mode only for the original
paper sizes shown on the touch panel display.
To select an A or B series paper size, press [A/B-size].
7. Press [-] or [+] to set the frame erase width.
To enter values in millimeters, press [mm].
When entering the value in millimeters, you can also use
–
(numeric keys), and (Clear) to clear your entry.
You can change the value by pressing [-] or [+], even if you have
entered the value using
– (numeric keys).
If you enter a value outside the setting range, a message
prompting you to enter an appropriate value appears on the
screen.
The maximum original frame erase width that you can set is <1
15/16" (50 mm)>.
If you want to set the same width for all four borders:
Press [-] or [+] to set the frame erase width, then press [OK].
If you want to set the top, left, right, and bottom widths
independently:
Press [Adjust Each Dim.].
Select the desired frame erase borders, then press [-] or [+] to set
their respective frame erase widths.
Press [OK].
To return to the screen for setting the same width for all four borders,
press [Adjust All At Once].
–
–
–
–
–
–
–
●
–
●
–
–
–
8. Press [Done].
9.
Press (Start).
To cancel this setting, press [Special Features] → [Frame Erase] →
[Cancel].
To cancel all settings and return the machine to the Standard
mode, press (Reset).
Book Frame Erase
This mode erases the dark borders, as well as center and contour
lines that appear if you are copying facing pages in a book or bound
original onto a single sheet of paper.
The Book Frame Erase mode cannot be used with the Image Combination
or Different Size Original mode.
1. Press (COPY).
2. Place your original on the platen glass.
3. Press [Special Features].
4. Press [Frame Erase].
5. Press [Book Frame Erase], then [Next].
–
–