Canon imageCLASS MF7470 - Manual (Page 175)

1
2
3
4
5
6
7
8
9
10
11
4-64
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
4. If you want to set a password for the Memory
Lock mode, enter a password using
– (numeric keys), then press [Next].
If you set a password, it will be necessary to enter the password
whenever you want to change the Memory Lock mode settings, or
cancel the Memory Lock mode.
If you do not want to set the Memory Lock with a password, press
[Next] without entering any numbers.
You cannot store a password that only consists of zeros, such as
<0000000>.
If you enter fewer than seven digits, the machine stores the
password with leading zeros.
Example: If <02> or <002> is entered, <0000002> is stored.
Since there is no way to check a stored password, make sure that
you write it down, and keep it in a safe place.
If you make a mistake when entering the password, press
(Clear) to clear your entry, then enter the correct password.
5. Specify the memory lock settings.
If you want to print an RX report:
Press [On] for <Report Print>.
If you do not want to print an RX report, press [Off ].
–
–
–
–
●
–
–
If you want to specify the Memory Lock Time Settings:
Press [On] for <Memory Lock Time Settings>, then press [Next].
Press [Memory Lock Start Time], then specify the time to enter
the Memory Lock mode using
– (numeric keys).
Press [Memory Lock End Time], then specify the time to exit the
Memory Lock mode using
– (numeric keys), then press [OK].
Enter all four digits of the time (including zeros), using 24-hour
notation.
Examples: 9:05 a.m. → 0905
4:18 p.m. → 1618
If you make a mistake when entering the time, press (Clear) to
clear your entry, then enter another four digit number.
If you do not want to specify the time, press [Cancel].
If you set the same time for Memory Lock Start Time and Memory
Lock End Time, the machine will be in the Memory Lock mode
through the entire day.
●
–
–
–
–
–
–
–