Canon imageCLASS MF7470 - Manual (Page 98)

1
2
3
4
5
6
7
8
9
10
11
3-27
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
6. Select the size of the bound original when it is
open, then press [Next].
You can set the Book Frame Erase mode only for the original
paper sizes shown on the touch panel display.
To select an A or B series paper size, press [A/B-size].
7. Press [-] or [+] to set the frame erase widths.
To enter values in millimeters, press [mm].
When entering values in millimeters, you can also use
–
(numeric keys), and (Clear) to clear your entries.
You can change the values by pressing [-] or [+], even if you have
entered the values using
– (numeric keys).
If you enter a value outside the setting range, a message
prompting you to enter an appropriate value appears on the
screen.
The maximum book frame erase width that you can set is <1
15/16" (50 mm)>.
If you want to set the same width for all four borders:
Press [Center] and [Sides].
Press [-] or [+] to set their respective frame erase widths, then
press [OK].
If you want to set the top, left, center, right, and bottom
widths independently:
Press [Adjust Each Dim.].
Select the desired frame erase borders.
Press [-] or [+] to set their respective frame erase widths, then
press [OK].
To return to the screen for setting the same width for all four borders,
press [Adjust All At Once].
8. Press [Done].
–
–
–
–
–
–
–
●
–
–
●
–
–
–
9. Press (Start).
To cancel this setting, press [Special Features] → [Frame Erase] →
[Cancel].
To cancel all settings and return the machine to the Standard
mode, press (Reset).
Binding Erase
This mode erases the shadows that appear on copies from binding
holes on originals.
The Binding Erase mode cannot be used with the Book ▶ 2-Sided, Two-
page Separation, or Different Size Original mode.
Do not place originals with binding holes into the feeder, as this may
damage the originals.
If you are using the Binding Erase mode, the borders you do not select
are also slightly erased.
1. Press (COPY).
2. Place your original on the platen glass.
3. Press [Special Features].
4. Press [Frame Erase].
5.
Press [Binding Erase], then press [Next].
6. Select the border where the binding holes are
located, then press [Next].
The border is where the binding holes are located on the original, if
you visualize the original as being face up.
–
–
–
–
–