Canon imageCLASS MF7470 - Manual (Page 171)

1
2
3
4
5
6
7
8
9
10
11
4-60
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
5. Press [Done] repeatedly until the Send Basic
Features screen appears.
Storing/Editing Favorites Buttons
You can set any possible combination of send settings and register
them in a favorites button in memory. There are 18 favorites
buttons and they can be assigned names for increased
convenience. This feature is useful for registering frequently used
send settings.
The send settings registered as favorites buttons in memory are not
erased, even if the power is turned off.
If an address included in a favorites button is deleted from the Address
Book, it is also deleted from the settings registered in the favorites
button.
Registering/Editing a Favorites Button
1.
Specify the send settings that you want to
register.
2. Press (Additional Functions).
3. Press [Communications Settings] → [TX
Settings] under <Common Settings> → [ ▼] →
[ ▼] → [Register Favorites Button].
The Register Favorites Button screen appears.
■
–
–
4. Select a Favorites Button ([M1] to [M18]) for
registering the send settings, then press
[Register/Edit].
If the desired Favorites Button is not displayed, press [ ▼] or [▲]
to scroll to the desired Favorites Button.
Keys that already have settings stored in them are displayed with
a black square in the lower right corner of the key.
5. Press [Register].
If you select a key that already has settings stored in it, the
settings are displayed.
If there are more stored send settings than are currently
displayed, you can scroll through the list by pressing [
▼] or [▲].
If you select a key without settings:
A screen appears, asking for your confirmation to store the
settings.
Press [Yes].
To cancel storing the settings, press [No].
The message <Stored in memory.> appears for approximately
two seconds on the touch panel display.
The stored settings are displayed.
If you select a key that already has settings stored in it:
A screen appears, asking for your confirmation to overwrite the
previous settings.
Press [Yes].
To cancel overwriting the settings, press [No].
The message <Stored in memory.> appears for approximately
two seconds on the touch panel display.
The stored settings are displayed.
6. Press [Name].
–
–
–
–
●
–
–
–
–
–
●
–
–
–
–
–