9 memory subsystem, Memory:snsr:cffast, Memory:snsr:cfslow – Boonton 4540 Peak Power Meter User Manual User Manual
Page 169: Memory:snsr:cwrg, Memory:snsr:cwsh, 9 memory subsystem -35, Memory:snsr:cffast? -35, Memory:snsr:cfslow? -35, Memory:snsr:cwrg? -35, Memory:snsr:cwsh? -35
Boonton 4540 Series RF Power Meter
Remote Operation
5-35
5.6.9 MEMory Subsystem
The MEMory group of commands is used to save and recall instrument operating configurations, and to edit and review user-
supplied frequency dependent offset (FDOF) tables for external devices in the signal path. Up to four configurations may be
saved, and two frequency dependent offset tables. Note, however that assigning a stored FDOF table to a particular
measurement channel is not a MEMory command; it is handled through the SENSe subsystem.
MEMory:SNSR:CFFAST?
Description:
Return the sensor high bandwidth (FAST) frequency cal-factor table.
Syntax:
MEMory:SNSR[1|2]:CFFAST?
Argument:
None, query only.
Valid Modes:
Any
MEMory:SNSR:CFSLOW?
Description:
Return the sensor low bandwidth (SLOW) frequency cal-factor table.
Syntax:
MEMory:SNSR[1|2]:CFSLOW?
Argument:
None, query only.
Valid Modes:
Any
MEMory:SNSR:CWRG?
Description:
Return sensor AC cal data.
Syntax:
MEMory:SNSR[1|2]:CWRG?
Argument:
None, query only.
Valid Modes:
Any
MEMory:SNSR:CWSH?
Description:
Return sensor smart shaping table.
Syntax:
MEMory:SNSR[1|2]:CWSH?
Argument:
None, query only.
Valid Modes:
Any