Boonton 4540 Peak Power Meter User Manual - Manual (Page 220)

Boonton 4540 Series RF Power Meter
Remote Operation 5-86
Table 5-1. SCPI COMMAND SUMMARY (continued)
MEMory[1|2]:SNSR:CFFAST?
Return the sensor high bandwidth (FAST) frequency cal-factor
table.
MEMory[1|2]:SNSR:CFSLOW?
Return the sensor low bandwidth (SLOW) frequency cal-factor
table.
MEMory[1|2]:SNSR:CWRG
Return sensor AC cal data.
MEMory[1|2]:SNSR:CWSH?
Return sensor smart shaping table.
MEMory[1|2]:SNSR:INFO?
Return the sensor ID and parameter data.
MEMory[1|2]:SNSR:LFLIN?
Return sensor smart shaping table.
MEMory[1|2]:SNSR:MESSage?
Return the sensor message data.
MEMory[1|2]:SNSR:TEMPCOMP?
Return the sensor temperature compensation table.
MEMory:SYST:LOAD
Load saved instrument setup by filename.
<character data> = "USER1" ... "USER25".
MEMory:SYST:STORe
Save instrument setup by filename.
<character data> = "USER1" ... "USER25".
OUTPut:EXTernal:LEVel[:POWer]
Set or return the power level for an external 1 GHz calibrator
output signal.
OUTPut:EXTernal:MODUlation
Set or return the output modulation state for the 1 GHz calibrator.
OUTPut:EXTernal:POLArity
Set or return the polarity of the duty cycle in the preset pulse
control mode of the external 1 GHz calibrator.
OUTPut:EXTernal:PRESent?
Return true if a Model 2530 external 1 GHz calibrator is connected
and powered up. Otherwise return false.
OUTPut:EXTernal:PULSe:CTRL
Set or return the pulse control mode of the external 1 GHz
calibrator’s pulse modulator.
OUTPut:EXTernal:PULSe:DCYCle
Set or return the duty cycle in percent in the Preset pulse control
mode of the external 1 GHz calibrator.
OUTPut:EXTernal:PULse:PERiod
Set or return the pulse period in the preset pulse control mode of
the external 1 GHz calibrator.
OUTPut:EXTernal:PULse:PERWID
Set or return the pulse period <arg1> and pulse width <arg2> in
seconds in the Variable pulse control mode of the external 1 GHz
calibrator.
OUTPut:EXTernal:PULse:SOURce
Set or return the pulse modulation source for the external 1 GHz
calibrator.