Boonton 4540 Peak Power Meter User Manual - Manual (Page 218)

Boonton 4540 Series RF Power Meter
Remote Operation 5-84
Table 5-1. SCPI COMMAND SUMMARY (continued)
DISPlay:SCREensaver:STATe Set/return state of screensaver mode. <Boolean> = { 0, 1, OFF,
ON }
DISPlay:SCREensaver:TIMe Set/return time until display dims. <numeric_value> = 1 through
180
DISPlay:[TEXt:]LIN:RESolution
Set number of significant digits for linear displays and remote
return values. <numeric_value> = 3 to 5
DISPlay:[TEXt:]LOG:RESolution
Set number of decimal places for log displays and remote return
values. <numeric_value> = 0 to 3
DISPlay:TRACe[1|2]:HOFFSet
Set/return the horizontal offset for statistical mode in dBr.
<numeric_value> = -50.00 to +50.00 dBr
DISPlay:TRACe[1|2]:HSCALE
Set/return the horizontal scale for statistical mode in dB/Div.
<numeric_value> = 0.1 to 5.0 dB/Div in 1-2-5 sequence
DISPlay:TRACe[1|2]:VCENTer
Change vertical center based on current units.
Ex:<numeric_value> = 1.23
DISPlay:TRACe[1|2]:VSCALe
Change vertical scale based on current units. Ex:<numeric_value>
= 20 set to 20dB/div (current units)
FETCh[1|2]:ARRay:AMEAsure:POWer? Return current Ppeak, Pavgcyc, Pavgpulse, Ptop, Pbot, Overshoot
FETCh[1|2]:ARRay:AMEAsure:STATistical?
Return current Pavg, Ppeak, Pmin, PkToAvgRatio, CursorPwr,
CursorPct, Sample-Count
FETCh[1|2]:ARRay:AMEAsure:TIMe?
Return current Freq, Period, Width, Offtime, Dcyc, Risetime,
Falltime
FETCh[1|2]:ARRay:CW:POWer?
Return current Pavg, Pmax, Pmin, Ppulse or Pk/Avg
FETCh[1|2]:ARRay:MARKer:POWer?
Return current Pavg, Pmax, Pmin, P/Avg, Pmrk1, Pmrk2,
Pmrk1/Pmrk2
FETCh:ARRay:TEMPerature:AVERage?
Return the average sensor temperature from CH1 and CH2.
FETCh:ARRay:TEMPerature:CURRent?
Return the instantaneous sensor temperature from CH1 and CH2.
FETCh[1|2]:CW:POWer?
Return current average reading in power units
FETCh[1|2]:INTERval:AVERage?
Return average power between MK1 and MK2.
FETCh[1|2]:INTERval:MAXFilt?
Return maximum filtered power between MK1 and MK2.
FETCh[1|2]:INTERval:MINFilt?
Return minimum filtered power between MK1 and MK2.
FETCh[1|2]:INTERval:MAXimum?
Return maximum instantaneous power between MK1 and MK2.
FETCh[1|2]:INTERval:MINimum?
Return minimum instantaneous power between MK1 and MK2.