Boonton 4540 Peak Power Meter User Manual - Manual (Page 263)

Boonton 4540 Series RF Power Meter
Appendix B 9-1
9. Appendix B Model 2530 1GHz Calibrator
9.1 Description
The Model 2530 operates as an accessory of the Boonton 4530 or 4540 Series RF Power Meters to provide calibration and
test signals at an output frequency of 1.024 GHz. The Model 2530 is controlled by the power meter through its manual and
remote programming systems. It appears in the menus for calibration and test signal output and GPIB commands are defined
for it. The 4540 series power meter equipped with the Model 2530 has two complete calibration and signal sources available.
The 1.024 GHz calibrator is useful for sensors that cannot be calibrated at 50 MHz because of a higher low-frequency cutoff.
It is also closer to commonly used frequencies for Telecom applications. A built-in pulse generator and modulator capability
provides a highly useful test signal.
Although controlled by the power meter, the Model 2530 contains an independent AC power supply. In normal use, the
calibrator circuits are continuously powered in standby mode for optimum thermal stability.
9.2 Accessories
Table 1-1
Accessories for the Model 2530
Selection Part Number Description
Standard
56810400A Line Cord (US)
960000501A Fuse Kit, 0.5A 250V
98102500A Instruction Manual, Model 2530
92023800A Interface Cable, RJ11, Model 2530 to 4530/4540 Series
95125001A Adapter, 4540 to 2530, HDB15 to RJ11
Optional
95403001A Rack Mounting Kit (Brackets only)
9.3 Optional Configurations
Model 2530.
Standard configuration – RF output connector located on the front panel.
Model 2530-01. Optional configuration – RF output connector located on the rear panel.
Other Options
Opt -30. Extend Warranty to 3 years.