Boonton 4540 Peak Power Meter User Manual - Manual (Page 205)

Boonton 4540 Series RF Power Meter
Remote Operation 5-71
SYSTem:COMMunicate:LAN:ADDRess
Description: Set or return the IP address for the Ethernet port.
Syntax: SYSTem:COMMunicate:LAN:ADDRess <character data>
Argument: <character data> = instrument IP address in nnn.nnn.nnn.nnn (―dot decimal‖) format
Valid Modes: Any for queries. DHCP/AutoIP must be disabled (OFF) to set the instrument IP address.
SYSTem:COMMunicate:LAN:DGATeway
Description: Set or return the default gateway for the Ethernet port.
Syntax: SYSTem:COMMunicate:LAN:DGATeway <character data>
Argument:
<character data> = default gateway IP address in nnn.nnn.nnn.nnn (―dot decimal‖) format
Valid Modes: Any for queries. DHCP/AutoIP must be disabled (OFF) to set the default gateway IP address.
SYSTem:COMMunicate:LAN:SMASk
Description: Set or return the subnet mask for the Ethernet port.
Syntax: SYSTem:COMMunicate:LAN:SMASk <character data>
Argument: <character data> = subnet mask in nnn.nnn.nnn.nnn (―dot decimal‖) format
Valid Modes: Any for queries. DHCP/AutoIP must be disabled (OFF) to set the subnet mask.
SYSTem:COMMunicate:LAN:DHCP[:STATe]
Description: Set or return the state of DHCP/AutoIP system for the Ethernet port.
If DHCP/AutoIP is enabled (1 | ON), the instrument will attempt to obtain its IP Address, Subnet
Mask, and Default Gateway from a DHCP (dynamic host configuration protocol) server on the
network. If no DHCP server is found, the instrument will select its own IP Address, Subnet Mask,
and Default Gateway values using the ―AutoIP‖ protocol.
If DHCP/AutoIP is disabled (0 | OFF), the instrument will use the IP Address, Subnet Mask, and
Default Gateway values that have been entered by the user.
Syntax: SYSTem:COMMunicate:LAN:DHCP[:STATe] <Boolean>
Argument: <Boolean> = { 0, 1, OFF, ON }
Valid Modes: Any.