Boonton 4540 Peak Power Meter User Manual - Manual (Page 265)

Boonton 4540 Series RF Power Meter
Appendix B 9-3
9.5 Connections
1. Plug the supplied RJ-11 cable into the rear panel jack of the 2530 and into the rear panel jack of a BOONTON
4530 or 4540 Series RF Peak Power Meter. Note that the 4540 connection requires use of the enclosed RJ11-
to-HDB15 adapter (p/n 95125001A) to connect the calibrator cable via the EXT CAL/VGA OUT connector.
2. Connect the AC power cord to a suitable AC power source.
3. Press the upper half of the rocker type power switch located in the power entry module on the rear panel.
4. The yellow LED on the front panel should illuminate and the 2530 is ready for use. The green LED will
illuminate only when the RF output is turned on.
Model 2530 Calibrator 4540 Series Powermeter
Figure 9-1 2530 Hookup Diagram