Videotec DCT - Manual (Page 129)

6.16.5 Patrol
In the Main menu press the PATROL to enter the menu for carrying out the specific function.
START LATEST TOUR
To start the latest TOUR to be selected.
STOP LATEST TOUR
To stop the TOUR in progress.
START TOUR 1...4
To start the corresponding TOUR. The sequence of
positions to be visited is set by OSM.
To enter the setup menu of the specific TOUR.
The AUTOPAN function makes use of Preset positions 1 and 2 of TOUR No. 4 as limit switch
positions. This means that the first time the START AUTOPAN key is pressed, any setting for
TOUR No. 4 will be lost..
6.16.5.1 Setup TOUR
WARNING!
Whenever the setup menu is entered, the parameters for the corresponding TOUR will be erased.
TOUR No. 4 is also used for the AUTOPAN function.
The following procedure is valid for all 4 TOURs.
Procedure for adding a position to the selected TOUR:
 Select field 1, press the “ ent ” key and insert the number of the Preset position that is to be reached by the
dome.
 Select field 1, press the “ ent ” key and insert the speed used to reach the position.
 Select field 1, press the “ ent ” key and insert the dwell time for when the position is reached.
 Select field 1, press the “ ent ” key to send the information to the dome.
To add other Preset positions, repeat the procedure from the beginning.
Press the “
esc ” key to return to the PATROL page.
The inserted data are only saved definitively by the dome when you exit the setup page.
Page 127 of 176 MNVADCT03_0716