Videotec DCT - Manual (Page 49)

4.4.1.1.1 Modify PRESET
The menu for modifying PRESET is used to store, in the controlled device, a series of positions of interest to
be reached by the dome/receiver.
Each position is associated with a number that is used to reposition the dome/receiver at the previously stored
point (using the SCAN control).
The maximum number of storeable positions depends on the controlled device. See the sections referring to
the corresponding domes and receivers to check the specific limits (see § 6 - TELEMETRY, page 71).
1. Keys for loading specific functions directly from this
menu
Procedure for inserting a Preset position:
 position the camera, also using the other available functions in the top of the display if necessary
 insert a numeric value within the maximum and minimum limits shown on the display and confirm with
the “
enter ” key.
To insert other positions or to change a previously inserted position, repeat the procedure from the beginning
4.4.1.1.2 Cancel PRESET
The cancel PRESET menu is used to delete a single Preset position stored in the controlled device. This
function is not available in all devices.
Procedure for deleting a Preset position:
 enter the numeric value of the Preset position be deleted and confirm with the “ enter ” key.
Page 47 of 176 MNVADCT03_0716
1