Videotec DCT User Manual
Page 76
When the key has been pressed the screen will ask for the camera number which is to have an address change.
In the example, the address of camera No. 2 is to be changed.
When the desired number has been keyed in it should be confirmed with the “
enter
” Key.
At this point the system asks for insertion of the new (physical) address. In the example the number is 81.
1. New camera address
2. Old camera address
Press the “
enter
” key.
The system returns to showing the active camera selection page but now camera 2 has the physical address 81,
no longer 2.
NOTES
If the address of the active camera is changed, at the end of the operation the camera must
be recalled again so as to activate the new setting.
The new physical address should correspond to the setting for the device to be controlled. Set
the DIP SWITCHES of the receiver or dome appropriately.
Page 74 of 176
MNVADCT03_0716
2
1