Videotec DCT - Manual (Page 84)

Code Function
63 Start autoscan for alarm
64 Stop autoscan for alarm
OTHER
71 Heater on
72 Fan on
73 Audio muting: mute
74 Light: on
75 IR Filter: cut filter mode
81 Heater off
82 Fan off
83 Audio muting: normal
84 Light: off
85 IR Filter: focus filter mode
PRESET POSITIONS
1000 Add all Preset positions
10XX XX = 01 ÷ 99: add one Preset position
1100 Remove all Preset positions
11XX XX = 01 ÷ 99: remove one Preset position
12XX XX = 01 ÷ 99: dwell time (in seconds) after reaching each position
1300 Movement at maximum speed
130X X = 1 ÷ 8: reduced speed of movement
ALARM POSITIONS
2000 Add all alarm positions
20XX XX = 01 ÷ 99: add one alarm position
2100 Remove all alarm positions
21XX XX = 01 ÷ 99: remove one alarm position
22XX XX = 01 ÷ 99: dwell time (in seconds) after reaching each position
2300 Movement at maximum speed
230X X = 1 ÷ 8: reduced speed of movement
TIMER FUNCTIONS
40XX XX = 00 ÷ 56: Stop autopan
00: continuous; 01 ÷ 23: from 5 to 115 minutes (step = 5 minutes); 24 ÷ 44: from 2 to 12
hours (step = 30 minutes); 45 ÷ 56: from 13 to 24 hours (step = 1 hour)
4XYY Reset Aux contacts
X = 1 ÷ 8: contact number
YY = 00 ÷ 28: time:
00: continuous; 01 ÷ 05: from 1 to 5 minutes (step = 1 minute); 06 ÷ 15: from 10 to 55
minutes (step = 5 minutes); 16 ÷ 27: from 1 to 12 hours (step = 1 hour); 28: 24 hours
Page 82 of 176 MNVADCT03_0716