Videotec DCT - Manual (Page 80)

6.2.3 Configuration
The dome is mostly configured by On Screen Menù.
Some parameter settings can be made by inserting a special code.
For all dome configuration operations the “Setup Telemetry” FUNCTION must be enabled (see § 4.2.4.5 -
Functions, page 35).
Connect the dome to the keyboard as described in the previous section, and a monitor to the video OUT on the
dome according to the general procedure (see § 6.19 - Operating procedure for setting a dome/receiver, page
137).
Go to the OSM setup menu for the dome (see § 6.1.5 - Layout of the configuration menus, page 76) where it is
possible to make the various parameter settings for the dome.
ENTER PROGRAMMING
To enter the dome OSM.
FOCUS KEY
To enter the submenus.
IRIS OPEN KEY
To exit the submenus / select some functions.
IRIS CLOSE KEY
To exit the submenus / select some functions.
Use the joystick to move between the various menus.
See the dome handbook for the correct parameter settiings.
6.2.4 Autoflip, Autopan, Focus, Iris
All these functions can be loaded by pressing the specific keys in the control menu area of the Main menu (see
§ 4.4 – Control menu area, page 45).
Check § 9.1 – Functions assigned to the most common graphics keys, page 164 and § 9.2.1 – Dome, page 165
to find out which functions are available for the dome.
If the SET/RESET Autoflip keys are pressed this will send the AutoPivot ON/OFF controls
described in the dome handbook.
See the dome handbook.
6.2.5 Patrol (Tour)
In the main menu press the PATROL button to enter the menu for carrying out the movement controls.
START TOUR
To start the TOUR.
STOP TOUR
To stop the TOUR.
For further details see the handbook for the dome itself.
Page 78 of 176 MNVADCT03_0716