Videotec DCT - Manual (Page 146)

Graphics submenu
On top of the grid there is a graphics submenu; the icons have the following meanings:
Disable all cameras.
If a camera has been selected, clicking on this icon will disable the selected camera and all the
cameras in the same line.
Acceptance and assignment of all cameras to Telemetry A.
If a camera has been selected, clicking on this icon will accept the selected camera and all the
other cameras in the same line, assigning them to Telemetry A.
Acceptance and assignment of all cameras to Telemetry B.
If a camera has been selected, clicking on this icon will accept the selected camera and all the
other cameras in the same line, assigning them to Telemetry B.
Passage from Telemetry mode to Physical Address mode and vice versa. The top left corner of the
grid shows which mode is active.
WARNING
If in the “General” card, Video/Type: DVR/MUX has been selected, an up/down field will
appear at the side of the graphics submenu, which can be used to select the DVR/MUX number
to which the cameras are assigned.
7.4.1.3.3 Monitors/DVR-MUX
The centre of the table contains a grid; each
cell of the grid represents a monitor or a
DVR/MUX.
To simplify identification, the column of
numbers on the far left contains the address
of the first monitor/DVR-MUX in each
line.
By checking the various checkboxes, the
user is able to accept the monitors
connected to a video matrix or the
DVR/MUX's controlled directly by the
keyboard.
For further information see § 4.2.4.2 -
Monitor / DVR-MUX connected locally,
page 31.
Graphics submenu
On top of the grid there is a graphics submenu; the four icons have the following meanings:
Disable all monitors/DVR-MUX.
Disable a complete line of monitors/DVR-MUX.
Accept all monitors/DVR-MUX.
Accept a complete line of monitors/DVR-MUX.
Page 144 of 176 MNVADCT03_0716