Lenze 2130IB - Manual (Page 18)

L
16
2.5. Manufacturer's Declaration
We hereby certify that the electronic controllers listed in these
Operating Instructions are control components for variable speed
motors intended to be assembled into machines or to form a machine
together with other components. According to the "Council directive ...
relating to machinery" 89/392/EWG, the controllers cannot be called
machines.
These Operating Instructions give advice and recommendations for
the installation and use of the electronic equipment.
As long as the conformity with the protection and safety guidelines
required by the "Council directive ... relating to machinery"
89/392/EWG and its amendment 91/368/EWG is not proved,
commissioning of the machine is prohibited.
The measures required for typically configured controllers to comply
with the EMC limit values are indicated in these Operating Instructions.
The electromagnetic compatibility of the machines depends on the
method and accuracy of the installation. The user is responsible for
the compliance of the machine with the "Council directive ... relating to
electromagnetic compatibility" 89/336/EWG and its amendment
92/31/EWG.
Considered standards and regulations:
• Electronic equipment for use in electrical power installations and
their assembly into electrical power installations:
DIN VDE 0160, 5.88
• Standards for the erection of power installations: DIN VDE 0100
•
Degrees of protection: EN 60529, 10.91
•
Base material for printed circuits:
DIN IEC 249 part 1, 10.86; DIN IEC 249 part 2-15, 12.89
• Printed circuits, printed boards:
DIN IEC 326 part 1, 10.90; EN 60097, 9.93
•
Creepage distances and clearances:
DIN VDE 0110 part 1-2, 1.89; DIN VDE 0110 part 20, 8.90
• Electrostatic discharge (ESD):
prEN 50082-2, 8.92, IEC 801-2, 9.87 (VDE 0843, part 2)
•
Electrical fast transient interference (Burst):
prEN 50082-2, 8.92, IEC 801-4, 9.87 (VDE 0843, part 4)
•
Surge immunity requirements: IEC 801-5, 10.93
•
Radio interference suppression of electrical equipment and
plants: EN 50081-2, 3.94; EN 55011 (VDE 0875, part 11, 7.92)
• Radio interference suppression of radio frequency equipment
for industrial purposes: VDE 0871, 6.78
2.5.1. Application as directed of the 2130IB module
The 2130IB module is an additional module for Lenze controllers of
the 4900, 8600, 9200 series. These controllers are industrial
equipment for use in industrial high power plants. They are designed
for use in machinery to control variable speed drives.
Further notes about the use can be obtained from the operating
instructions of the corresponding controller.