Rockwell Automation 1771-PD PID MODULE (+DU) - Manual (Page 22)

Aseembly and Installation
Chapter 2
2Ć9
Part C)
Record the required programming plug positions on table 2.D using your
selections on table 2.C for reference. Select LEFT/RIGHT, IN/OUT or
TOP/BOTTOM so that Table 2.D has a position defined for every E
location.
1. Using your selections inTable 2.C for reference, mark the
corresponding plug positions in the right-hand column of Table 2.D
Table 2.D. For example, if the required condition for output is
minimum value due to hard fault or loss of +5V dc, mark the IN
position in Table 2.D for E5.
Part D)
Set programming plugs E2 and E10 on the digital board using Table 2.B
and the following procedure:
1. Remove the unmarked left cover plate to gain access to the digital
circuit board.
2. Refer to Figure 2.2 to identify the location of the user-selectable and
factory configured programming plugs.
3. Set programming plugs E2 and E10 according to the functions
circled in Table 2.B.
4. Verify that the factory configured programming plugs are installed as
shown in Figure 2.2
5. Set the completed digital board, cover, and screws to one side.
Part E)
Set the programming plugs on the analog board usingTable 2.D and the
following procedure:
1. Remove the right cover (with the terminal identification label) to
gain access to the analog circuit board.