Rockwell Automation 20D PowerFlex 700S with Phase I Control Reference Manual - Manual (Page 167)

Rockwell Automation Publication PFLEX-RM002D-EN-E - August 2013 167
Detail Drive Configuration and Operation Chapter 1
Speed Synchronization Example:
This example describes how to setup SynchLink to synchronize the ramped, s-
curved speed reference for two PowerFlex 700S drives using DriveExecutive.
Note that the Peer Communication setup in DriveExecutive configures the
appropriate SynchLink parameters for you as you go through the setup.
Once connected to the drive, select Peer Communication from the Drive menu
on the menu bar.
A dialog box similar to the one shown below displays. This is the dialog box used
to setup SynchLink communication.