Rockwell Automation 20D PowerFlex 700S with Phase I Control Reference Manual - Manual (Page 172)

172 Rockwell Automation Publication PFLEX-RM002D-EN-E - August 2013
Chapter 1 Detail Drive Configuration and Operation
The Parameter 1000 - SL Node Cnfg Properties dialog box opens.
4. Verify that only the Sync Now check box is checked (this is the factory
default).
5. Click OK.
The SynchLink communication dialog box re-opens.
6. Click OK,
You must link the speed reference bypass of the follower to Word 0 of
Direct Data coming over SynchLink.
7. Open the Properties dialog box for Parameter 37 [Spd Ref Bypass].
8. Click on the Link Data tab.