Rockwell Automation 20D PowerFlex 700S with Phase I Control Reference Manual - Manual (Page 46)

46 Rockwell Automation Publication PFLEX-RM002D-EN-E - August 2013
Chapter 1 Detail Drive Configuration and Operation
Digital Outputs Technical Information
There are three digital outputs on the I/O board.
Digital Outputs 1 and 2 are 24VDC open collector (sinking logic). They are
rated 25 mA maximum.
Figure 11 - is an example of how Digital Outputs 1 and 2
would be used with a light.
Note: The transistor in the diagram is the internal circuitry of the Digital
Output. When the logic for Digital Output 1 becomes true, the transistor turns
on, tying the transistor's collector to ground and completing the circuit. Then the
light will turn on.
Figure 11 - Digital Outputs
Digital Output 3 is a relay output rated for 24VDC. The relay output is rated 5 A
at 24VDC for a resistive load, and 2 A at 24VDC for an inductive load.
Figure 12 - Digital Output Configuration
Digital
Output
Common
(Return)
T6
Sinking
Ouput
G + 24V DC
Digital
Output
Logic
T4
841
842
Relay Out Data
Relay Out Bit
16
Local I/O Status
(Output Relay)
TB2-B5
TB2-B4
843
844
Dig Out 1 Data
Data Out 1 Bit
17
Local I/O Status
(Aux Out 1)
TB1-T6
TB1-T5
845
846
Dig Out 2 Data
Data Out 2 Bit
Local I/O Status
(Aux Out 2)
18
TB1-T4
{Return "Common"}
824
824
824