Lk-g-m-no4-e, Binary output, 4 input/output terminals – KEYENCE LK-G Series User Manual
Page 128
4-16
4
LK-G-M-NO4-E
4 Input/Output Terminals
Binary output
• OUT1 and OUT2 are updated asynchronously depending on the filter settings or the options speci-
fied in the measurement mode.
• This timing chart is the example of the state other than OUT1: Normal, and OUT2: Normal.
• Output of either OUT1 or OUT2 can be selected for binary output by "OUT1/OUT2 SEL input".
• You can check whether the present binary output is OUT1 or OUT2 by "OUT1/OUT2 OUT output".
• Synchronize the binary data with the STROBE output signal to import.
• The input response time (T2) and refresh rate (T5) vary depending on the settings.
• The STROBE time (T3) can be changed.
Refer to page 4-17.
Refer to page 3-43.
ON
OFF
OUT1/OUT2
SEL input
ON
OFF
Binary data output
ON
OFF
OUT1/OUT2
OUT output
ON
OFF
STROBE output
OUT1
ON
OFF
ON
OFF
OUT2
T5
Sampling period
MaxT2
OUT1
OUT1
OUT1
T6/2
T6/2
0.2ms
T3
OUT1
OUT2
OUT2
MaxT2
measurement value
measurement value