KEYENCE LK-G Series - Manual (Page 69)

3-11
3
LK-G-M-NO3-E
3 Function Settings
■ Setting procedure of the ABLE calibration
1
Hold down the key, and select " kEAd-A " with the key.
"Head A" is set in this example.
2
Press the key, and select function " d " with the key.
Set the ABLE calibration process.
3
Press the key to display " StArt ". Press the key
again to start measurement.
" StoP " indicates that the target is being measured.
4
Press the key to register the measurement result.
Press the key to return to the measurement state.
OUT1 HI GO LO
HI GO LO
TIM
OUT2 TIM
HI GO LO OUT2 TIM
OUT1 HI GO LO TIM
OUT1 HI GO LO TIM
HI GO LO OUT2 TIM
HI GO LO OUT2 TIM
OUT1 HI GO LO TIM