Change the height of the printhead, Changing printhead height, P.2-43 – Canon W8400 User Manual
Page 104: Change the height of the printhead -43, Changing printhead height -43, Index contents
2- 43
Change the height of the printhead
Chapter 3
Printing by Objective
Chapter 7
Operating the
Function Menu
Change the height of the printhead
It is possible to achieve the higher print quality by adjusting
the height of the printhead. Follow the procedure below to
operate.
Use the following procedure.
Change the height of the printhead. (
Set a cut sheet of the type you intend to use.
(
)
Aligning the Printhead. (
Printing. (
)
After completing the special print job, return the
printhead height to its original setting and re-align the
printhead. (
→
)
Important
z
If the printhead height was changed, make sure to
adjust the print status. If adjustment is not performed,
optimal printing results cannot be obtained.
z
When printing on paper-base media (ex: Coated
Paper, Plain Paper) or any type of media that wrinkles
easily, never print with the printhead lower than the
best height for each media. This could also damage
the printer.
Note
z
Press the Information button to check the current
height of the printhead using Head Heigh, and the
optimum height for the paper type selected.
Changing Printhead Height
1
Press the Online button to display MAIN
MENU.
2
Press [
] (or [
]) to select Chng Head
Hght then press [
].
3
Press [
] or [
] to select Yes, then press
OK button.
The carrige moves to the center when you see
Carriage Moving.
Chng Head Hght
=Yes
Data
Information Power
Message
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)
MAIN MENU
Head Cleaning
Data
Information Power
Offline
Menu
Message
MAIN MENU
Chng Head Hght
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)