Adjusting the amount of media feed, Media feed adjustment procedure, P.4-43 – Canon W8400 User Manual
Page 288: Adjusting the amount of media feed -43, Media feed adjustment procedure -43, Index contents
4- 43
Adjusting the Amount of Media Feed
Chapter 3
Printing by Objective
Chapter 7
Operating the
Function Menu
Adjusting the Amount of Media Feed
Use the following procedure to run the Adjust Band
function to adjust the amount of media feed if you see white
lines or dark color lines in your printed images. The printer
prints the band adjustment pattern and reads the resulting
printout as it prints it to automatically adjust the setting for
the amount of media feed for the media currently loaded in
the printer. The amount of media feed can be set for
different types of media. Before executing the adjust band
function, make sure roll media or cut sheets of A3 size or
wider are loaded in the printer.
Important
z
Before you adjust the amount of feed, you must use
the operation panel to select the media type of the
paper loaded in the printer. If the value of the media
type selection does not match the paper loaded in the
printer, you will not achieve good print results and the
quality of the printing will be poor.
z
To perform Adjust Band, select Band Joint in Feed
Priority.
Note
z
If you are using cut sheets, make sure you load at
least one sheet of unused A3 paper or larger (not the
blank side of used paper).
z
There is no automatic adjustment for highly
transparent film. Execute Fine Tuning to perform the
adjustment with manual entry.
Media Feed Adjustment Procedure
1
If the printer power is off, press the Power
button to turn the printer on.
Within a short time, Online or Offline is displayed.
2
Press the Online button to display MAIN
MENU.
3
Press [
] or [
] to select Adjust Printer
then press [
].
MAIN MENU
Adjust Printer
↓
Data
Information Power
Offline
Menu
Message
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)
MAIN MENU
Head Cleaning
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)