Index top contents – Canon W8400 User Manual
Page 313
5- 17
TCP/IP Network Settings (Windows, Macintosh, UNIX)
Chapter 3
Printing by Objective
Chapter 7
Operating the
Function Menu
5
Configure each of the settings.
, Use
BOOTP, or Use RARP. If the IP address is static,
clear all three check boxes.
Note
z
If the printer IP address is configured to use DHCP,
BOOTP, and RARP, a check is performed to see which
of DHCP, BOOTP, and RARP is available when the
printer is turned on or reset, and the IP address is
allocated using first available method. If you clear the
checkmark from Use DHCP, Use BOOTP, or Use
RARP, that particular method will not be checked.
If none of the address allocation methods are
available, the printer is assigned the IP address that
was configured in the IP Address field.
z
The check to determine whether DHCP, BOOTP, or RARP
are available requires approximately 1 to 2 minutes to
execute. It is therefore recommended that you clear the
checkboxes for the methods that are not available.
z
When DHCP, BOOTP, or RARP is used to assign the
IP address, the server for that protocol in the network
must be running.
z
If you are using a DNS server, tick the Enable DNS
Dynamic Update checkbox, and then enter the Primary
DNS Server Address, Secondary DNS Server
Address, DNS Host Name, and DNS Domain Name.
z
Enter the DNS Host Name using English letters, numbers,
and hyphens to a maximum of 63 characters. Numbers and
hyphens cannot be used as the first character, and hyphens
cannot be used as the last character.
z
Enter the DNS Domain Name using English letters,
numbers, hyphens and periods to a maximum of 64
characters. Numbers, hyphens, and periods cannot be
used as the first character, and hyphens and periods
cannot be used as the last character.
6
Click the OK button.