Configuring tcp/ip protocol settings, Setting the protocol with web browser (remote ui), Configuring tcp/ip protocol settings -15 – Canon W8400 User Manual
Page 311: P.5-15, Index top contents
5- 15
TCP/IP Network Settings (Windows, Macintosh, UNIX)
Chapter 3
Printing by Objective
Chapter 7
Operating the
Function Menu
Configuring TCP/IP Protocol Settings
“Remote UI”, the software application built into the network
interface of this printer, allows you to use a Web browser on
your computer to monitor the status of the printer and
perform the network information settings for the printer.
Setting the Protocol with Web Browser
(Remote UI)
The procedure below describes how to use Remote UI to
perform the network information settings.
Important
z
You can use Netscape Navigator/Communicator 6.0 or
later, or Internet Explorer 5.01 or later for the web
browser. The Macintosh Safari web browser is not
supported.
z
You cannot connect to the printer via a proxy server. In
an environment that uses a proxy server, add the
printer IP address to Exceptions (addresses that do
not use a proxy) in the web browser proxy server
settings. (These settings vary depending on the
network environment.)
z
Configure the web browser to enable JavaScript and
Cookies.
z
If multiple Remote UIs are run at the same time, the
last setting made will be used. It is recommended that
only one Remote UI be started at a time.
Note
z
When Remote UI is started using the printer name,
make sure that the DNS settings in the DNS
environment and on the network board have been set
up correctly.
1
Start the Web Browser and enter the
following URL in the Location or Address
box, then press the Enter key.
http:// <Printer IP Address or name> /
Sample: http://XXX.XXX.XXX.XXX/