Netware settings (windows), Procedures required for a netware network, Netware settings (windows) -33 – Canon W8400 User Manual
Page 329: Procedures required for a netware network -33, P.5-33, Index top contents
5- 33
NetWare Settings (Windows)
Chapter 3
Printing by Objective
Chapter 7
Operating the
Function Menu
NetWare Settings (Windows)
The chapter describes the configuration procedures for
using a printer connected to a NetWare network.
Procedures Required for a NetWare
Network
The following is a summary of the procedures required to
setup the printer for use on a NetWare network.
The following procedure should be performed by the
network system administrator.
1
Installing the network interface board
→ Quick Start
Guide
First, install the optional network interface board.
2
→
Connect the LAN port of the printer to the hub using a
network cable.
3
Setting the Printer Frame Type
→
Set the printer frame type. Use the following software
to configure the printer so that it can communicate
with the computer you are using.
• GARO Device Setup Utility (Canon software
application provided with the printer.)
• Printer Operation Panel
4
Setting Up a NetWare Print Service
Configure the NetWare print service. You can
configure the settings from a computer using the
following software.
• NWADMIN or PCONSOLE (Novell software
applications provided with NetWare)
5
Setup the printer protocols. Setup the printer
protocols using a web browser on a computer on the
network.
• Web Browser (Remote UI)
6
Configuring the Computer for
NetWare
Perform these settings on every computer that will
use the printer.