Canon W8400 - Manual (Page 364)

6- 17
‹ Message Is Displayed
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Scale Read Error
Cause 1: The carriage has malfunctioned.
Solution 1: Open the top cover and make sure a foreign
object has not fallen into the printer.
Solution 2: Turn OFF the printer, wait for 3 seconds min.,
and then turn ON the printer again.
Solution 3: If the message appears again after doing the
procedure above, read the content of the
message and write down the first line, turn OFF
the printer, and then contact a Canon service
center.
Mist Full Soon
Cause 1: The printer ink mist processing has become full.
(Just before the following “Mist Count Error” is
displayed.)
Solution 1: The current print job can continue. If performing
banner printing or borderless printing, the print
job may stop while incomplete, so contact your
Canon customer service center.
Mist Count Error
Cause 1: Printer ink mist processing limit has been
exceeded.
Solution 1: Write the message displayed on the top line of
the printer display on a memo, and then turn
OFF the power supply, and consult your Canon
customer service center.
Cut.Move Timeout
Cause 1: The optional cutter unit (Round cutter) is not
moving.
Solution 1: Open the top cover, and remove the foreign
object from the optional cutter.
Cause 2: The optional cutter unit is broken.
Solution 1: Write the message displayed on the top line of
the printer display on a memo, and then turn
OFF the power supply, and consult your Canon
customer service center.