Canon W8400 - Manual (Page 93)

2- 32
‹ Printing with Rolls Media
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
9
Hold the end of the paper, and lift the release
lever.
10
While gently pulling out the center of the
leading edge of the roll media to the ejection
guide (f), align the right edge of the media
with the right side of the paper alignment line
(g), then pull down the release lever.
Important
z Make sure to carry out Step 9 and 10 . Otherwise, the
paper may not be feed straight, or the paper may
become wrinkled causing a paper jam or friction on the
printhead.
z Do not pull strongly on the roll media when you align it
with the paper alignment line (g). The roll media may
not feed out straight in some cases.
Note
z If the release lever is open, the platen paper suction
can be adjusted. If it is difficult to load the paper, adjust
the suction using the [
] button (stronger) and [ ]
button (weaker) on the operation panel.
11
Close the top cover.
Media Type is displayed.
12
Press the [ ] or [ ] buttons to select the
loaded media type, and then press the OK
button.
If the same type of media already matches the
loaded media, just press the OK button.
The selection is prefixed with an equals sign (=) to
indicate the roll media type that is selected.
f
g
Media Type
HW Coated