Canon W8400 - Manual (Page 323)

5- 27
‹ Macintosh Network Settings
トップ
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
TOP
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
4
To configure the AppleTalk protocol settings,
click the Edit button to the right of
AppleTalk.
The Edit AppleTalk Protocol Settings page is
displayed.
If you are using the Zeroconf function in MacOS X or
IP Print (Auto) in MacOS 8.6/9.x to connect to the
printer, go to
Step 9 .
5
Set the Phase Type to Phase 2.
Note
z If Disabled is selected, the printer will not be
recognized by the AppleTalk network.
6
Enter the name of the printer on the network
in the Name field.
Enter the printer name displayed in Chooser ( Mac
OS 8.6/9.x) or the name displayed in Print Setup
Utility (Print Center) (Mac OS X).
Important
z If more than one printer is in the same zone, be sure to
assign a unique name to each printer.
Note
z The initial (default) network phase Name is “Canon NB
15FB (xxxxxx)”, where xxxxxx is the 6-digit MAC
address of the printer.