Canon W8400 - Manual (Page 362)

6- 15
‹ Message Is Displayed
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Turn Power Off!!
Cause 1: The tape inside the top cover or the belt stopper
have not been removed.
Solution 1: Turn OFF the printer, open the top cover,
remove the tape and belt stopper, and then
press the Power button. (
→ Quick Start Guide)
Cause 2: Media has jammed in the printer.
Solution 1: Turn OFF the printer and remove the jammed
sheet, reset the media, and then turn ON the
printer again. (
→ P.6-37 )
Cause 3: The printer has malfunctioned.
Solution 1: Turn OFF the printer, wait for 3 seconds min.,
and then turn ON the printer again.
Solution 2: If the message appears again after doing the
procedure above, read the content of the
message and write down the first line, turn OFF
the printer, and then contact a Canon service
center.
ERROR E02E01
Turn Power Off!!