Compuprint 4247-X03 - Manual (Page 117)

Chapter 8. Printer setup
Paper Source . . . . . . . . . . . . . 101
Front Forms Backup . . . . . . . . . . . 102
Rear Forms Backup . . . . . . . . . . . 103
Continuous Forms Linking . . . . . . . . . 104
Form Feed Mode . . . . . . . . . . . . 105
Controlling tear off operations. . . . . . . . 106
Using automatic eject to control forms eject . . 106
Using automatic restore to control restoring of
forms .
. . . . . . . . . . . . . . 106
Automatic Eject . . . . . . . . . . . 107
Automatic Restore. . . . . . . . . . . 108
Continuous Forms Eject Mode. . . . . . . . 109
Bar Code Print Direction . . . . . . . . . 110
Graphics Print Direction . . . . . . . . . . 111
Perforation Safety . . . . . . . . . . . . 112
Jam Sensors . . . . . . . . . . . . . . 113
This chapter describes the procedures for checking and changing printer setup
parameters for your 4247 printer. The chapter is divided into sections according to
parameter. Refer to this partial table of contents for parameter and page listings.
Paper Source
The Paper Source parameter defines the current paper source for the printer. The
values displayed on the operator panel depend on the forms devices installed in
the printer. The paper source setting can be set to any of the following values:
Front (Default) The front paper path is assigned according to the forms tractors installed
on the printer. The front paper path settings apply to the paper loaded
with the tractor already installed on the printer, if the second (optional)
tractor is not installed. If the second (optional) tractor is installed in the
printer, the front paper path settings apply to the paper loaded on this
second optional tractor.
Rear The rear paper path settings apply to the paper loaded with the lower
tractor, when the second (optional) tractor is installed on the printer.
To change or check the Paper Source:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Setup
Paper Source
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
paper source is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
101